Plumbing, Heating & Air Conditioning In Aliquippa, PA

Bathroom Plumbing Repair: Dispatched to a residence with a toilet that continuously ran and a leaking bathroom sink. Replaced the toilet flapper, adjusted the fill valve, and replaced the faucet cartridge. Inspected the supply lines and drain connections, tightened and sealed all fittings, and tested multiple flush cycles and water flow to ensure complete resolution of leaks and proper operation.

Custom HVAC System Installation: Arrived to install a zoned HVAC system in a newly built two-story home. Installed a high-efficiency air handler, added motorized dampers in the main trunk lines for each zone, mounted and programmed thermostats for individual rooms, and tested airflow, temperature, and zone responsiveness. Verified each zone reached target temperatures efficiently and confirmed quiet, balanced operation.

Commercial Water Heater Replacement: Dispatched to replace a large-capacity water heater supplying a busy commercial kitchen. Drained and removed the old unit, installed a high-efficiency replacement, connected gas and water lines, verified correct pressure relief valve operation, and performed multi-fixture flow testing to ensure the system met peak demand without interruptions.

Heating Services: Arrived to inspect a furnace failing to maintain even heat across multiple rooms. Found the blower wheel covered in dust and several duct dampers partially closed. Cleaned the blower assembly, adjusted dampers for proper airflow, verified gas pressure and ignition performance, and tested heating cycles to confirm consistent temperature distribution throughout the home.

Indoor Air Quality: Dispatched to address persistent musty odors and allergy complaints in a home. Installed a UV light unit in the air handler near the evaporator coil, sealed duct transitions, verified proper electrical connections, and tested airflow. Measured particle counts before and after installation to confirm improved air quality and reduction of biological contaminants.

Sewer Repair: Dispatched after a commercial property reported recurring backups in floor and utility drains. Conducted a camera inspection, identified grease and debris accumulation in the main line, and discovered minor cracking in a section of pipe. Performed hydro-jetting to remove obstructions, applied epoxy patching on the cracked section, and tested all fixtures to ensure proper flow and prevent future blockages.

Water Filtration System Installation: Arrived to install a whole-home filtration system for a household concerned about sediment, chlorine, and taste issues. Mounted the filtration unit in the basement, connected to the main water line, installed shutoff valves, and flushed the system. Tested water at multiple faucets for clarity, flow, and taste, ensuring proper filtration throughout the home.

Commercial HVAC: Dispatched to a commercial location where cooking equipment was creating high humidity and uneven temperatures. Inspected rooftop HVAC units, cleaned condenser and evaporator coils, lubricated fan motors, calibrated thermostats, and tested airflow under full kitchen load. Verified consistent cooling, proper humidity control, and reliable operation for staff and equipment.

Air Duct Cleaning: Arrived at a residence reporting reduced airflow and dusty interior. Removed vent covers and performed mechanical brushing and vacuuming of all supply and return ducts. Cleaned the evaporator coil, sanitized key duct sections, and replaced filters. Tested airflow throughout the home and confirmed improved HVAC efficiency and better indoor air quality.

Kitchen Plumbing: Responded to a kitchen experiencing both a leaking faucet and slow sink drainage. Disassembled the faucet to replace worn cartridges, removed the P-trap and cleared accumulated food debris and grease, and inspected the drain line for further blockages. Reassembled all connections, tested water flow under full pressure, and verified leak-free operation.

Water Heater Repair: Arrived to troubleshoot a tank-type water heater producing lukewarm water intermittently. Inspected the unit and discovered sediment accumulation in the tank and a failing upper heating element. Drained and flushed the tank, replaced the element, verified thermostat operation, and tested water temperatures at multiple taps to ensure consistent and safe hot water delivery.

Bathroom Plumbing: Dispatched to a home where the master shower drain was slow and causing minor water pooling on the floor. Inspected the drain line using a hand auger and discovered hair and soap buildup combined with mineral deposits. Used a motorized drain snake to break up the obstruction, followed by hydro-jetting to thoroughly flush the pipes. Tested multiple shower and sink drains, confirmed smooth water flow, and advised the homeowner on regular maintenance to prevent future clogs.

Bathroom Sink Installation: Dispatched for new bathroom sink installation in the client’s guest bathroom. Removed existing sink and prepared plumbing connections. Installed new sink and faucet assembly, connected supply lines and drain, and sealed mounting surfaces. Tested for leaks, verified proper drainage, and confirmed secure installation and normal water flow.

Heating System Maintenance: Performed scheduled heating system maintenance. Inspected burners, heat exchanger, inducer motor, and blower assembly. Checked electrical connections, tested safety controls, and verified ignition sequence. Cleaned flame sensor and burner assembly, replaced air filter, and confirmed correct gas pressure and airflow. Cycled system and verified efficient, safe operation.

Commercial Bathroom Plumbing: Dispatched to repair a commercial urinal with a malfunctioning automatic flush system and minor leaks. Diagnosed a defective sensor and leaking supply line. Replaced the sensor, repaired the supply line connection, and tested multiple flush cycles to ensure proper sensor activation, consistent water flow, and leak-free operation.

Water Heater Repair: Arrived on-site to troubleshoot a hybrid water heater that was not heating efficiently. Tested both the heat pump and electric backup elements, discovering a faulty upper heating element and reduced airflow through the heat pump. Replaced the heating element, cleaned the intake and exhaust filters, verified proper airflow, and tested recovery time and water temperature to confirm optimal performance.

Duct Cleaning: Dispatched for poor airflow and excessive dust concerns. Inspected duct system and found heavy buildup of dust and debris within supply and return lines. Performed full duct cleaning using professional vacuum and agitation equipment. Cleaned registers and return grilles, sealed access openings, and verified improved airflow and cleaner air circulation.

Bathroom Plumbing Repair: Dispatched to replace a leaking and non-functional bathroom faucet. Shut off water supply, removed the old fixture, cleaned the mounting area, and installed a new faucet. Reconnected supply lines, checked for leaks under full water pressure, and tested hot and cold operation as well as handle rotation to ensure smooth and leak-free functionality.

Plumbing Repair Service: Arrived to repair a dishwasher that would not fill properly. Tested the water supply line and valve, identified a faulty water inlet valve restricting flow. Replaced the valve, verified proper voltage and water pressure, and ran a full wash cycle to confirm the dishwasher filled correctly and completed cycles without issues.

Heating System Replacement: Evaluated aging heating system with declining performance and high repair frequency. Removed existing furnace and prepared duct, gas, electrical, and vent connections. Installed new properly sized high-efficiency heating system, connected utilities, and verified airflow and combustion. Completed startup procedures and tested multiple heating cycles to confirm safe and reliable operation.

Whole-House Humidifier Installation: Installed a new whole-house humidifier to improve indoor air quality and reduce dry air. Mounted humidifier to supply duct, connected water line and drain, and wired unit to operate with furnace blower. Set humidity control to recommended level and tested operation. Verified proper water flow and even moisture distribution throughout system.

Heating Repair: Dispatched for heating system shutting down due to overheating. Inspected airflow, limit switch operation, and blower performance. Found severely restricted airflow caused by dirty filter and blocked return vents. Replaced air filter, cleared obstructions, and verified blower operation. Reset safety controls and cycled system through multiple heating stages to confirm stable temperatures and proper operation.

Commercial Plumbing Repair: Dispatched to a commercial restroom sink with slow drainage. Inspected the P-trap and drain line, identified buildup and partial obstruction. Cleared the drain using a mechanical auger, flushed the line, and tested water flow to ensure proper drainage. Verified no leaks in the trap or piping.

Water Heater Installation: Arrived to install a new tankless water heater to replace an inefficient tank unit. Mounted the unit, connected gas supply and cold/hot water lines, installed proper venting per manufacturer specifications, and programmed the temperature settings. Tested multiple fixtures to verify consistent hot water flow and correct operation under variable demand.

Kitchen Plumbing Installation: A homeowner requested installation of a new dishwasher and sink sprayer during a kitchen upgrade. Evaluated the existing hot and cold supply lines as well as the drain configuration, then installed the required extensions to accommodate the new fixtures. Connected the dishwasher discharge line, installed the sprayer assembly, and secured all plumbing fittings. Performed thorough leak testing on all connections and verified proper operation. The homeowner was left with a fully functional, updated, and efficient kitchen plumbing setup.